|
July Update
PE100 RC Pipe (Resistance to Crack)
A fundamental and critical component of any efficient performing Ground Source Heat Pump System are the collector pipes where pipe protection and longevity are paramount.
It's widely accepted in terms of good pipe laying practice that sand should be employed both below and above the pipe to protect from sharps as even PE100 Pipe Material is vulnerable to rapid creep if point load damage occurs.
Whilst sand does offer the potential for improved thermal conductivity in poor soils it has become the default position on most installs to lay a sand bedding as traditionally pipe needed protection from the variants of “as dug material” thereby always adding that cost into the job in material and significant labour time.
Go Geothermal Limited can offer you a solution, PE100 RC. Offering low notch sensitivity and superior resistance to point loading and slow crack growth (SCG), the RC material avoids the potential for pipe tears even when point loads caused by rocks occur.
By utilising this pipe in the correct soil conditions NO sand back fill is required! This reduces capital outlay and significant labour time and plant on site.
Go Geothermal are pleased to offer this product as yet another step in the improvement of the technical quality of Ground Source materials.
40mm Pipe coils up to 500m in length
Just in case you're not aware, we now stock 40mm coils right the way up to 400m in length (500m are available direct from the factory). Coils of 300m and greater are the thinner walled variety (SDR17, 2.35mm, 10 bar rated).
Heat Transfer Fluids – Solar & Air Source
The fluids utilised in your Ground or Air Source unit are critical in the efficient operation of the system here at GG we not only stock the leading manufacturers we can advise of the benefits of the different brands including which brands are recommended by the respective HP manufacturers.
Solar fluid is also a product we are able to supply as more installs are integrating the different technologies using buffer tanks. This way the installer can be sure of the high quality that they already enjoy from GG on the solar fluid as well.
Chambers
With every GSHP installation criteria can be different on site; not all houses and gardens are the same. Likewise commercial & public installs have their different challenges.
It's why when GG looked at housing the essential manifolds which are key to any efficient GSHP install we knew one solution would not suffice. The Pre formed sealed Manifold Chamber has many functions and lends itself to a quicker install (time on site reduced) but it is restrictive in terms of options and height adjustment for example.
Our quick assembly chamber has been very popular for over two years but as we are always listening to feedback from the market our products adapt accordingly. To this end we are now stocking 2 chamber sizes which can be assembled simply without all the disadvantages of traditional brick & block.

The beauty of this method is that the chambers are built up in 150mm sections so can accommodate variable heights & multiple entry points for the collectors if needed. The design is also capable of far greater loadings if required as they are already proven in the M.O.D and Highway applications.
The two sizes stocked accommodate most installs but bespoke sizes are available on request.
Please click here for more details.
SENTINEL have long been synonymous with innovation in the world of fluids and their range of energy efficient fluids is no exception.
GG stock a full range of their fluids including the Air Source R600 as recommended by leading OEM Manufacturers and we are happy to offer a sentinel engineer on any project for advice and training where required.
Pre insulated pipe is available in both PEXA and Polybutylene and can be supplied to site within 3-5 days with no minimum order charge!
Look out for more market leading solutions next month from GG the source in Ground,Water & Air Source.
April Update
New for April we now stock Rehau Everloc pipe and fittings upti 50mm ideal for any internal plumbing where the reliability of PEXA and certainty of jointing is paramount.
Go Sustain thermal transfer fluid the truly green option when it comes to fluid for your closed loop system. A derivative of Corn in the form of Bio Glycol this product now offers the choice to go fully sustainable. Its low viscosity means it can even offer improved flow characteristics in certain applications.
15 & 22mm pre insulated PEXA pipe now available through GG designed for hot and cold water applications. It boasts a CFC free and HCFC free closed cell polyethylene insulation. It will improve the energy rating (SAP) of any building!
New Innovations from Go Geothermal
Pre insulated Pipe
Pre insulated pipe is available in both PEXA and Polybutylene and can be supplied to site within 3-5 days with no minimum order charge. Suitable for Ground Source, Air Source and Biomass.

Air Source Preinsulated Pipe Kits
Air-source heat pumps are often situated away from the building and the heated water must be efficiently transported back to the building. The thermal insulation on our Air Source is provided by a closed cell polyurethane foam which provides optimum heat insulation and even remains water-tight if outer jacket is damaged.

Your Requirements
Here are the advantages of the RAUTHERMEX ASHP Kit:
• Flexible installation in the soil under the frost limit level
• Flow/Return together in a pre-insulated pipe
• Straight length max. 25m, leaving with a 90° angle upwards of 1.2m
• Staggered, 32mm straight lengths of 5m, 10m, 15m, 20m, 25m
• Optional wall duct into the house
• No cutting or insulation joint necessary, saving approx 2-4 hours on site
The Solution
We offer a unique system package on the market that is exactly coherent to your needs with the following advantages:
• Unique, mounted complete package
• All articles included for the connection between the heat pump and the heating system in your house
• Individually tailored to the needs of the customer
 
12 steps for 2010 we at Go Geothermal would like you to consider!
Genuine one stop shop for all your Geothermal needs from stock with delivery next day for orders received by 2:30pm.
Obvious choice when the need to deal with a specialist supplier and not a general merchant with a bolt on renewable business is paramount.
Great diversity of range from PEX Probes ideal for heat dumping and unrivalled resistance to temperature and notch damage of vertical and horizontal collectors to 40mm sdr17 coils up to 500m available in 48hrs typically to site!
Even offer Thermal transfer fluid which carries a 5 year guarantee on service life for ground and air source when used with our Pre treatment Steriliser.
Offer advice and experience from a truly independent perspective always striving to offer service levels far above the industry standard.
The only UK distributor of both vertical pe100 16bar probes and PEX probes. PE probes come with a service life of >25 years, Factory Welded & Tested. PEX probes are so superior they come with a £10,000 guarantee per borehole!
Having one supplier of all your Geothermal Needs alleviates multiple carriage charges, reduces administration costs and saves time when talking with contacts that understand your requirements first time.
Ensuring new technologies and innovations are always added to the range such as our coil dispensing trailers and Pre-Insulated PB pipe.
Rigorously searching the market to source within the UK wherever possible in line with our carbon reduction aims such as never ever using New Box packaging only recycled boxes from day one!
M aking sure we listen to our customer’s future needs we now offer Air to Air and Air to Water Heat Pumps including the latest CO2 refrigerants coping with up to minus 25deg outside air temperature. We also offer a Pre Insulated pipe for the Biomass Market and Electrically conductive plastic pipe for blown pellet delivery.
All your tooling needs can be catered for whether you require our bespoke Electrofusion control unit complete with full data retrieval via USB and light pen, or full mechanical jointing method electric PEX tooling featuring Everloc fittings 500 Million joints plus - No Failures!
Last but most importantly we are committed to listening to our lifeblood you the customer if we are not meeting your expectations if something is missing from our range let us know either via the website or give us a call.
|